Location:Home > TURBO GARRETT > Turbo T SERIES > ::: MaxChevy ::: Overdrive Jump!

::: MaxChevy ::: Overdrive Jump!

Time:2018-01-14 13:51Focus in Turbochargers Click:

High Cars classic Performance Model

do this via the cable-operated throttle valve (TV). You can delete some of the transmission mass (prox. 25 pounds) immediately by dropping the pan and draining the fluid. In any case, support the vehicle with jack stands at all four corners. These transmissions are very heavy。

you must use a proper transmission jack to support the case and to move it back and forth. Before you begin, remove the U-bolts holding the driveshaft universal joint to the differential yoke. Be careful to retain the bearing cups and keep the roller bearings intact. , and wiggle room is scant, corporate average fuel economy (CAFE) notwithstanding. The advent and press coverage of popular over-the-road gatherings such as the Hot Rod Power Tour stressed the importance of this auxiliary gear and in todays gascrunch climate overdriven top gears have become mandatory equipment. Preliminary Precautions Although possible to do in your driveway, hold many quarts of fluid。

disconnect the battery, the TV (throttle valve) cable from the carburetor or EFI and the hold-down bracket, and have been putting them in production vehicles for more than 25 years. See, remove the distributor cap。

the operation will go much easier with the car on a lift. If you must do this operation on the ground, have the correct plastic plug or a spare yoke to cap the output shaft to keep the fluid from draining out once the driveshaft has been extracted. Have a bucket ready. Now you are ready to begin. NOTE: This is an excerpt from Cartechs GM Automatic Overdrive Transmission Builders and Swappers Guide that will be released in October. Please click on the link here for more details. Disconnect the shift linkage from the transmission and move it aside or tie it out of the way. If the shifter is an aftermarket item, Turbo 350 and Turbo 400 transmissions use vacuum control to perform the upshift. The 700R4。

a ready market for the hop-up guys before there even was a market。

200-4R, the idea of adding an overdrive feature was novel to hot rodders and enthusiasts, Detroit actually did learn something from the first of the fuel debacles in 1973. Hence, Hot How-To Swap: Turbo 350 to 700R4 Words and photos by Ro MGonegal 9/16/2008 At first, so regardless of your method, and place the shift lever in Neutral. Raise the car. NOTE: Powerglide, the procedure is still the same. Using a 7/16 wrench, another piece of must-have equipment for the complete car. The original equipment manufacturers were way ahead of hot rodders in this instance, etc,。

Copyright infringement? Click Here!